Redball® Pattern Check

Successful applications depend on your spray tips and proper operation of your sprayer equipment. The Pattern Check is a visual aid that helps determine whether spray patterns are correct. It will show a uniform distribution pattern when the pressure, boom height, nozzle spacing and spray tips are working correctly.

Pattern Check

What Causes Tip Failure?

Several factors can contribute to spray tip failure:
  • Clogged strainers or spray tip
  • Excess or low boom pressure
  • Worn spray tips
  • Incorrect overlap
  • Damaged spray tips
  • Incorrect height

How It Works

To use the 34" x 46" Pattern Check lay it flat below the spray tips. After spraying on Pattern Check's corrugated surface, raise it to a vertical upright position. The ball indicators will then rise in the captured fluid to indicate levels of distribution.

NEW SPRAY TIPS
Produce a uniform distribution when properly overlapped.
WORN SPRAY TIPS
Have a higher output with more spray concentrated under each tip.
DAMAGED SPRAY TIPS
Have a very eratic output over-applying and under-applying.
sub-content-bottom

Pattern Check

Photo Gallery
Photo Gallery


Brochure
Brochure


Contact
Contact & Support

Willmar Fabrication, LLC | Willmar, MN | 320.214.7888
Copyright © 2014 Willmar Fabrication, LLC | Website Design by E*Tap Marketing
The WF®, Redball® & SeedMobile® marks and "Put a Hood on Drift."™ are trademarks of Willmar Fabrication, LLC.
Always read and follow chemical directions. Follow state and local regulations.